Dodge Tigear-2 Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Urządzenia przemysłowe Dodge Tigear-2. Dodge Tigear-2 2 stron. Accessory kit
Również dla Dodge Tigear-2: Instrukcja obsługi (8 strony)

Drukuj stronę

10. If changing to Shaft Position "L," clean the bore in the

gearcase housing and install a new output bore plug in the

gearcase housing. Clean the bore in the bearing cover and

install a new output shaft seal in the bearing cover. Install

the plug and seal 1/16" below flush with the outside of the

gearcase or bearing housing.

11. If changing to Shaft Position "R," clean the bore in the

gearcase housing and install a new output shaft seal in

the gearcase housing. Clean the bore in the bearing cover

and install a new output bore plug. Install the plug and seal

1/16" below flush with the outside of the gearcase or bearing

housing.

12. Remove and keep together the tapered bearing cup and

shims from the bearing cover and place them in the gearcase

housing bore. Place the tapered bearing cup and shims that

were previously removed from the gearcase housing and

place them in the bearing cover.

13. Wrap vinyl electrical tape around the entire output shaft

extension to protect the lip seal during assembly. Do not

extend the tape onto the portion of the shaft which the seal

contacts during operation.

Figure 3 - Shaft Tape

Dodge Industrial, Inc.

1061 Holland Road

Simpsonville, SC 29681

+1 864 297 4800

AN RBC BEARINGS COMPANY

14. Apply a small amount of reducer oil drained in Step 1 to the

taped shaft extension to help slide the extension through the

output seal. If the reducer is being changed to Shaft Position

"R," place the reducer housing on blocks to provide room for

the shaft extension. Insert the output shaft assembly, shaft

extension down, into the reducer housing. If the reducer

is being changed to Shaft Position "L," insert the output

assembly, shaft extension up, into the reducer housing.

15. Remove the original o-ring from the bearing cover and install

a new o-ring.

16. Install the bearing cover onto the gearcase housing. If the

bearing cup and shims fall out of the bearing cover, apply a

liberal amount of oil to the bearing cup's outside diameter and

reinstall the bearing cup and shims into the bearing cover.

The oil will hold the parts in the bearing cover.

17. Install the four bearing cover bolts and lockwashers and

torque the bolts in a cross pattern to the following values:

Reducer

Size

18. Remove the vinyl electrical tape from the output shaft

extension and place the reducer with the fill and drain plug

hole facing up.

19. Fill the reducer with the oil drained in Step 1. Install and

tighten the oil fill and drain plug. Standard temperature range

replacement lubricant is available from Dodge. Contact

Dodge Product Support for details.

CAUTION: Do not substitute or add any other kind of oil or

premature reducer failure may occur.

Bolt Torque

(Inch–Pounds)

156

276

420

1320

*1614-0422*

MN1614 04/22