1010 Music Bitbox Podręcznik użytkownika - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt nagrywający 1010 Music Bitbox. 1010 Music Bitbox 11 stron.
Również dla 1010 Music Bitbox: Skrócona instrukcja obsługi (2 strony)
Drukuj stronę
More Clip Information
To see additional parameters from the
screen
More
button or press the INFO button. You will then see the
More Clip Info
On the
More Clip Info
parameters by turning the Control Knob closest to the parameter on the
screen:
Loop Mode
Pitch
Quant Size
Slice Size
P. 5
v. 1.0
Clip Info
screen shown on the right.
screen you can adjust each of the four
With Loop Mode ON, playback will continue to repeat the portion of the sample
specified by the
Start
This parameter adjusts the tone and the playback speed of the sample--unless you are
using slicing. It is expressed in semitones and ranges from -24 semitones (down two
octaves) to +24 semitones (up two octaves).
This parameter enables you to quantize when the playback starts and stops. It has the
following values available:
None - always start and stop immediately
●
1/16 - quantize to the next sixteenth note time
●
1/8 - eighth note
●
1/4 - quarter note
●
1/2 - half note
●
1 bar - a whole note assuming 4/4 time
●
2 bars
●
4 bars
●
8 bars
●
Example: With the quant time set to 1 bar, samples will start and stop when the next bar
or measure begins. You can see the current bar and beat in the upper left of most
screens.
When this parameter is enabled, bitbox will subdivide the sample into pieces that will
play in sync with the clock. The available values are the same units as the
Size
. For drum samples, small values like 1/8 or 1/16 work best. For drones or pads,
larger numbers like 1 bar may sound best. This parameter is only valid when
Size
is something besides
screen, touch the on-
and
Length
parameters on the
None
.
Bitbox User Manual
©1010music 2016
Clip Info
screen.
Quant
Quant