Cyfral CC-4000 Instrukcja obsługi, instalacji i programowania - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi, instalacji i programowania dla System interkomu Cyfral CC-4000. Cyfral CC-4000 8 stron. Control electronic

Drukuj stronę
Cyfral CC-4000 Instrukcja obsługi, instalacji i programowania
COMM:
 G
Signal ground
 B
Serial communication B
 A
Communication series A
 S
Audio speaker signal
 M
Audio sound microphone
 H
Differential video signal (positive)
 L
Differential video signal (negative)
SLAVE:
 +12V
Positive supply of the panel
 GND
Supply ground of the panel
 SERB
Communication series B
 SERA
Communication series A
 SPK
Audio speaker signal
 MIC
Audio sound microphone
 GND
Video signal ground
 VPH
Differential video signal (positive)
 VPL
Differential video signal (negative)
MASTER:
 GND
Supply ground of the panel
 SERB
Communication series B
 SERA
Communication series A
 SPK
Audio speaker signal
 MIC
Audio sound microphone
 GND
Video signal ground
 VPH
Differential video signal (positive)
 VPL
Differential video signal (negative)
LINE:
 L-
Uniphone ground voltage
 L+
Uniphone line
 VL
Differential video signal(negative)
 VH
Differential video signal(positive)
2.
D
EVICE DESCRIPTION
CC 4000 control electronics is a device that fulfils the function of an entry system private control panel. It receives
commands from the call panels and controls uniphones/monitors. It includes a full duplex sound channels, a sound
splitter and a video splitter. It contains all subscriber settings such as:
 Table of subscribers. Each physical address of the uniphone has a subscriber number assigned to it in the range of
1-9999. E.g.: If to a physical address No. 5 a subscriber No. 100 is assigned, then after entering "100" on the
keypad the control panel will send to the uniphone line a command to ring for the uniphone addressed with the
jumpers on No. "5". By default, the subscriber table is set to 1:1 for all 255 physical addresses
~3~