Dog Care WELL-D SD EC11 Skrócona instrukcja obsługi
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Produkt do pielęgnacji zwierząt domowych Dog Care WELL-D SD EC11. Dog Care WELL-D SD EC11 5 stron. Dog training collar
Drukuj stronę
DogCare WELL-D SD Dog Training Collar (Model: EC-11) FAQ's
1. Can't turn on Remote.
a.
Please make sure the remote is charged. Plug the charging cable into the port at the
bottom of the remote and the other end into a working power outlet. Charging should
take about 2 to 3 hours. (It is suggested to charge only for 2 to 3 hours to preserve longer
battery life).
b. After charging, twist the knob on the top left of the remote clockwise. The remote should
beep and the screen should light up. The battery level will be indicated by the bars shown
on the battery.
2. Can't turn on the Receiver.
a. Please make sure the Receiver (collar) is charged. The light on the receiver (collar) should blink
green if it is charged. If it needs to be charged it will turn red. Plug the charging cable into the
port at the bottom of the receiver and the other end into a working power outlet.
Charging should take about 2 to 3 hours. (It is suggested to charge only for 2 to 3 hours to
preserve longer battery life).
b.
Press and hold the ON / OFF button on the top of the Receiver until the collar makes a
double beep and vibrates (press it hard).
3. The Receiver/Collar does not respond.
a. Make sure the receiver and the remote are both charged and have enough power.
b. Make sure the receiver and remote have been paired. (See #6).
c. Check to see that both units are turned on.
d. If you have more than one receiver check your remote control and make sure that the
receiver is on the corresponding channel. (Test the different channels if necessary by
changing the channel with the button on the right side of the remote and pressing the beep
or vibrate button to confirm. Re-pair if necessary. See #6).
e. Press the beep and/or the vibrate button to test the response. (To test the shock see #9).
4. The Receiver/Collar is not charging.
a. When not in use the collar automatically turns off after about 6 to 8 hours. If any
button is pushed the time is extended.
b. Turn ON the Receiver/Collar first and then the Remote Control. Test the collar by
pushing the vibrate or beep button.
5. The collar turns off on it's own.
WELL-D SD
Dog Training Collar
(Model: EC11)