Dogtra 2700T&B Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Produkt do pielęgnacji zwierząt domowych Dogtra 2700T&B. Dogtra 2700T&B 19 stron. 1-dog system only training & beeper collar

Drukuj stronę

5. Collar Fitting

Proper Fit

The collar should be fitted so that the surgical stainless

steel contact points press firmly against the dog's skin.

You should be able to fit a finger in between the contact

point and your dog's skin. The best location is on either

side of the dog's windpipe.

Improper Fit

A loose fit can allow the collar to move around on the

dog's neck. When this happens, the contact points may

rub against the skin and cause irritation. If the collar is

too loose, the contact will not be consistent and cause

the corrections to be inconsistent. Dogtra uses surgical

stainless steel contact points and anti-microbial plastic

to protect the dog's skin.

Attention!

Leaving the receiver/collar in the same location on

the dog's neck for an extended period of time can

cause skin irritation. If the dog is to wear the e-collar

for long periods, occasionally reposition the collar

so that the contact points are moved to a different

location on the dog's neck. Make sure you check for

skin irritation each time you use the unit.

6. Finding the Right Stimulation

Intensity Selection

The 2700T&B has a Rheostat Dial on the top of the

transmitter (0 is the lowest and 127 is the highest).

Remember that you will need to adjust the setting

(upward or downward) depending on your dog's

temperament and threshold for stimulation. Also, as

the dog's attitude changes, especially during times of

increased excitement or distraction, you may need to

adjust the intensity level.

Note: The stimulation intensity can be adjusted even

when the stimulation is in use.

7. Familiarizing the Dog to the Beeper

Turn the beeper collar on and leave it outside the dog's

kennel area for about 30 minutes. Repeat this several

times until you can see that the dog disregards the

beeper. Next, adjust the beeper volume level to level

L1, the lowest level. Fit the beeper collar on the dog

and select the desired beeper volume level as the dog

becomes accustomed to the beeping sound.