Aseptico ADU-17X Express II Instrukcja obsługi i konserwacji - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Sprzęt dentystyczny Aseptico ADU-17X Express II. Aseptico ADU-17X Express II 16 stron. Portable dental system
Drukuj stronę3. Mount the clip-on Holder to the extended handle of
the Case, as shown in Figure 3.
Fig. 3
Clip-On
Holder
Handle
Handpiece
3-Way
Syringe
4. Attach a sterile handpiece to the ISO Type B
(4-Line) handpiece connector and place the
handpiece in Holder (Fig. 3).
5. Remove the 3-way air/water Syringe from its travel
clip inside the Case and place it in the Holder.
6. Position the Waste Tank in the Case with the large
white connection to the rear left of the instrument
as shown in Figure 4. Attach the hose connector
coming from the Vacuum Motor to this large white
connection. Connect the High Volume Vacuum
(HVE) hose to the large gray connector located on
Fig. 4
Bungee
Cord
Low
Volume
Connector
Waste Tank
Saliva
Ejector
HVE
Vacuum
Motor
Connector
Water
Reservoir
Connector
High
Volume
Connector
Water
Supply
Bottle
the front of the Waste Tank. Connect the Low
Volume Vacuum (Saliva Ejector) hose to the black
connector located on the front of the Tank.
Note: When attaching the Saliva Ejector hose to
the top of the Waste Tank, push in and rotate 1/4
turn (see Figure 5).
TO INSTALL SALIVA EJECTOR HOSE,
TURN CONNECTOR 1/4 TURN CLOCKWISE
Fig. 5
7. Secure Waste Tank by running Bungee Cord from
hooks on bottom panel overtop Tank lid. Verify that
the Waste Tank and vacuum lines are properly
installed. Hang the High Vacuum and Saliva
Ejector instruments on the Clip-On Holder.
8. Fill the Water Supply Bottle with clean water and
connect to the Water Reservoir Connector.
9. Place Foot Switch on the floor.
VACUUM LINE
WITH QUICK
DISCONNECT
5.