Akrobat GRASSHOPPER Instrukcja instalacji i obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Sport i rekreacja Akrobat GRASSHOPPER. Akrobat GRASSHOPPER 16 stron.

Digging the trampoline pit

Position the frame on the location you chose and mark the position on the ground. It's best to

mark out a hole a bit wider than the diameter of your trampoline.

This will make it easier for you to put the frame in and find the right level. Dig the pit to the

following dimensions:

TRAMPOLINE SIZE

Dimension A – Frame diameter

10x6ft / cca. 305x183 cm

11x8ft / cca. 335x244 cm

The hole should not accumulate water (in which case the drainage is necessary) and it should be

possible to clean during maintenance.

Start digging the hole 15 cm inside from the frame diameter, deepening the pit towards the middle,

where it needs to be 90 cm deep.

AKROBAT HINT:

It's a relatively easy task to hand dig the hole for smaller size trampolines, but it would be best to hire a

mini digger able to excavate most of the soil and leave you with the finishing touches.

Placing the trampoline above the pit

When the hole is dug, place the trampoline

above this pit. Make sure the jumping mat is

positioned precisely above the hole.

Fix the legs of the trampoline with the pins. Push

each pin through the hole on the trampoline

leg as shown on the picture. Make sure the pins

are firmly attached to the ground.

INSTALLATION AND USER MANUAL - GRASSHOPPER

Dimension B – Pit diameter

275 x 153 cm

305 x 214 cm

Dimension C – Total depth

90 cm