Dogtrace d-control easy Podręcznik użytkownika - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Produkt do pielęgnacji zwierząt domowych Dogtrace d-control easy. Dogtrace d-control easy 19 stron. Electronic training collar

Drukuj stronę

Programming (matching) of the remote controller and the receiver

Every remote controller has its own RF operational code. Programming of the remote controller with

the receiver (collar) will be take place during the first use of the Dogtrace d–control set or with a new

remote controller or a receiver (when former or latter is lost). This operation will enable you to match

your remote controller with the delivered receiver (collar).

IMPORTANT: Before programming is started (before using your receiver for the first time or before

code rewriting) make sure that no one else uses his/her d–control or another product made by

Dogtrace in your neighbourhood – your receiver might randomly receive the code from another

remote controller and set itself to it. If this happens, program your receiver once again, using your

remote controller.

Turn on your transmitter.



Touch the lower part of your remote controller to the target on your receiver (see the photo on



page 8). The green LED will be permanently lit and after some 6 seconds, it will switch to the pro-

gramming mode, indicated by permanent flashing of the red LED.

Now take your transmitter away and press down the sound signal button



controller. The codes will be matched in this step and your receiver will produce a sound signal.

on your remote