DogWatch Performance Series Instrukcja obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Produkt do pielęgnacji zwierząt domowych DogWatch Performance Series. DogWatch Performance Series 16 stron. Hidden fence systems
Również dla DogWatch Performance Series: Instrukcja obsługi (14 strony), Instrukcja instalacji (10 strony), Instrukcja obsługi (13 strony)
Drukuj stronę
The transmitter sends a coded digital FM radio signal through the boundary wire. This
signal can be adjusted, allowing you to control the "hidden fence" around your property.
9
Rate
Switch
L
1
M
POWER
Power
On/Off
Power Supply
ever adjust the transmitter while your dog is wearing the receiver collar.
1. Power On/Off: This switch gives you easy access to turn the transmitter on or off.
The red Power light on the front panel lets you know that it is operating.
2. Power Supply: The transmitter is powered through a power supply that is plugged
into a properly grounded 110 volt outlet. The adapter is plugged into the transmitter
jack labeled "PWR."
3. PowerPak™: The optional battery back-up keeps the transmitter operating in the
event of a power failure. When transmitter is being powered by battery back-up, the
red power light will remain off. PowerPak plugs into the transmitter at "P-PAK".
4. Ground Wire: The green ground wire is plugged into the transmitter at the location
labeled "GND." The round connector on the green ground wire is attached under
the screw on the outlet faceplate. It will, however, only be effective if your outlet is
properly grounded. If you have any questions about having a properly grounded
outlet, consult your local electrician.
5. Loop Plug: Your system comes with zip cord with a plug on one end. This plug fits
into the hole marked "Loop" on the bottom of the transmitter. This is the beginning
of the boundary wire. Once your boundary wire has been properly installed and
plugged into the transmitter, the green Loop indicator light will turn on. If the
boundary wire is broken or the signal is interrupted, the Loop indicator light will go
out and an audible warning will sound. If the Loop light is out, consult your Dealer.
You should also check around your property for a visible broken wire.
PT4 Transmitter Features
3
2
RATE
1
ON
OFF
Hidden Fences
www.dogwatch.com
DIGITAL FM DESIGN
M
M
PWR
P-PAK
Performance Series PT4
2
3
PowerPak™
TRAINING MODE
M
GND
4
Ground Wire
3
A L
B M
Training
Mode
RANGE
10+
Range
8
6
4
2
Loop
M
LOOP
Monitor
Display
5
Loop Plug
8
7
6