CYP CPLUS-V10E Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Konwerter mediów CYP CPLUS-V10E. CYP CPLUS-V10E 16 stron. 1 by 10 6g hdmi splitter
Drukuj stronę6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
1
POWER: This LED will illuminate when the device is connected to an
active power supply.
2
6G/3G: When input source bandwidth is 6G, the 6G LED will
illuminate, when input source detect as 3G, the 3G LED will
illuminate.
3
IN SYNC: When input detected, the LED will illuminate, the LED will
flicker when detected abnormal, for example, when source signal
not stabled, and when input is not connected, the LED light will off.
IN HDCP: When Input HDCP has been detected, the LED will
4
illuminate, the LED will flicker when HDCP abnormal, for example
when HDCP version is not supported, and when no HDCP
detected, the LED will off.
5
OUT 1~10 SYNC: When output detected, the LED will illuminate,
the LED will flicker when detected abnormal, for example, when
output connected but the output sense is off, and when output is
not connected, the LED will off.
6
OUT1~10 HDCP: When output HDCP working, the LED will illuminate,
the LED light flicker when HDCP abnormal, for example, when
HDCP version is not supported, and when no HDCP detected, the
LED will off.
7
EDID: Switch the dip could choose EDID mode to Standard (STD)
mode or TV mode. When on TV mode, the unit will automatically
detect and store output 1 sink EDID data, if switch to STD mode,
the unit will set to standard 1080p and PCM 2 channel.
8
SYS-RST: Switch the dip from off to on, the unit will trigger TV to its
HDMI input1 immediately, when dip stays in on, the unit will trigger
cycle in every 8~10 minutes. (*The purpose of this function is to
guarantee output display the corresponding image, for example,
3
3
5
POWER
6G
IN
OUT 1
OUT 2
OUT 3
OUT 4
3G
1
2
4
6
OUT 5
OUT 6
OUT 7
OUT 8
OUT 9
OUT 10
SYNC
HDCP
STD
+
EDID
SYS-RST
TV
ON
OFF
7
8