Ashbys SENSEI Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odkurzacz Ashbys SENSEI. Ashbys SENSEI 13 stron.

Before Operating the Machine

Operators and maintenance personnel must read and understand this manual before attempting to

operate the unit. This manual has important information for use and safe operation. Keep this manual on

file and readily available.

Unpacking & Inspection

Carefully unpack and inspect the compact extractor for shipping damage. Each unit is inspected and

operated at the factory prior to shipping. Any damage should be reported to the carrier / supplier

immediately.

Set Up & Operation

Warning: Use only Ashbys approved water extraction detergent mix. Do not use chemicals intended for

pre-spray or rotary use. These will invalidate machine warranty.

1. Connect Sensei mains lead to 13 amp socket. Only use electrical supply with earth leakage trip.

If your Sensei is fitted with an internal heater, water in the solution tank can be heated to a pre-

set temperature of approx. 75˚C.

To turn on the internal heater ensure heater element & low level float switch are covered by

water.

1. Switch on mains power.

2. Now switch on the heater switch - a red light may come on depending on water

temperature.

The light will switch off if the water is a desired temperature. The heater will only operate

when the water temperature below is fixed thermostat setting & water level is above the

low level safety cut-off.

2. Fill the solution tank with water and cleaning solution. Solution tank can be filled to within

approx. 2 inches of solution tank lid.

3. Connecting Vacuum & Solution Hoses – The vacuum hose is the larger of the two hoses, and this

is used to collect the dirty water. The solution hose carries the water from the machine to the

tool head.

To connect the vacuum hose, simply push one cuffed end onto the Sensei's hose barb – located

to the right of the main switch panel. The solution hose has two brass fittings (one at either end)

– these are self-sealing. The male fitting is the plug end, and the female fitting is the socket. Pull

back the outer sleeve of the female fitting on the machine and push the male fitting of the hose

into it – then release the sleeve. This has now "locked" the solution hose onto your machine.

4. Attach desired cleaning tools - The tools you receive with your Sensei will depend on the

package. However, they all connect to the hoses in basically the same way. The male connector

Page 4 of 13