CYP PU-22HC Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przełącznik CYP PU-22HC. CYP PU-22HC 16 stron. V1.3 hdmi/cat6 to hdmi/ cat6 cascader
Również dla CYP PU-22HC: Instrukcja obsługi (10 strony)

Drukuj stronę

7. Operation Controls and Functions

The following sections describe the hardware components of the unit.

7.2 Front Panel

HDMI/CAT6 input selection: Switch to select input sources either from

①

HDMI or CAT6.

EDID Control Switcher: Default factory setting is TV, leave as if the display

②

is properly. Switch to STD to use built-in EDID.

[Note]:

1. When EDID switch to TV, the unit will detect the ﬁ rst HDMI's output EDID and

record in the unit. If the ﬁ rst detected HDMI output is DVI it will pass to next

output until the ﬁ rst HDMI output detected.

The detection priority is HDMI v1.3 > HDMI v1.2 > DVI.

2. When EDID switch to STD the unit will use built-in EDID which supports:

Video → 1080p 8-bit (max)

Audio → PCM 2CH

3. When EDID is switch to STD with input selection on HDMI or CAT6 IN the

display TV or monitor will switch to HDMI input 1, automatically. When EDID

is switch to TV regardsless of the input selection the display TV or monitor

will switch to HDMI input 1 mode. Therefore, it is not suggested to switch

the EDID to STD.

4. The EDID selection will only activate when the unit is re-plug and power on.

CEC output: When switch to HDMI ONLY, the HDMI output port ' s CEC will

③

bypass the CEC commend directly to the HDMI and CAT6 input ports.

When switch to HDMI and CAT6, the HDMI and CAT6 output port ' s CEC will

bypass the CEC commend cross to the HDMI .

HDMI Input: Connect input port to the HDMI or DVI output port of your

④

source equipment such as DVD player or set-top-box.