CYP PU-2H8HBTE-AD Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przełącznik CYP PU-2H8HBTE-AD. CYP PU-2H8HBTE-AD 16 stron. 2 x 8 hdbaset switch with audio dembedding

Drukuj stronę

6. OPERATION CONTROLS AND FUNCTIONS

6.1 Front Panel

1
IR Window: Receive IR signal from the package included remote
control only.
2
POWER Button & LED: Press this button to switch ON or set the
device to standby mode and the LED will illuminate in Green and Red.
3
SYNC: This LED will illuminate when the HDMI input port connected
to the source.
4
HDMI IN 1/2: Press the button to selection HDMI input source 1 or 2.
The LED will illuminate according to the selection.
5
HDMI & CAT OUT LINK 1~8: These link LEDs will illuminate when
HDMI or CAT5e/6/7 output(s) has been connected to the Display/
Receiver(s) and the Receiver(s) has connected with display that shows
image on screen.

6.2 Rear Panel

8
7
6
1
CAT5e/6/7 OUT 1~8: Connect these ports to CAT5e/6/7 to HDMI
Receivers (with or without PoE function) with CAT5e/6/7 cable to
extend the signal up to 100m.
2
IR OUT: Connect with IR Blaster to blast out the IR signal received
from the Receiver side. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
3
IR IN: Connect with IR Extender to receive IR signal from Transmitter
side and blast out at Receiver side. Ensure that remote controller
8
HDMI
HDMI
POWER
SYNC
IN 1
IN 2
1
2
3
4
CAT5e / 6 / 7 OUT
5
4
3
2
1
CAT5e / 6 / 7 OUT
HDMI
LINK
LINK 1
LINK 2
LINK 3
LINK 4
LINK 5
LINK 6
5
2
IR OUT
L/R OUT
OPTICAL
HDMI
1
LAN
OUT
OUT
IR IN
3
4
5
6 7
LINK 7
LINK 8
11
HDMI
HDMI
DC 24V
DC 24V
IN 2
IN 1
RS-232
EDID
SERVICE
STD
TV
8
9 10 12