CYP CH-1107 TX Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Nadajnik CYP CH-1107 TX. CYP CH-1107 TX 12 stron. Hdmi v1.3 over one cat6 hdmi transmitter
Również dla CYP CH-1107 TX: Instrukcja obsługi (10 strony), Instrukcja obsługi (12 strony)

Drukuj stronę

7.2 Rear Panel

① EDID Control Switcher: Switch the EDID between STD and TV. Switch to

STD to use the built-in EDID or switch to TV to use the TV's EDID. The default

factory setting is TV, leave as is when the display is working properly.

Note: 1. When EDID is switched to STD the unit will use its built-in EDID which

supports:

Video → 1080p 8-bit, 10-bit or 12-bit (max)

Audio → PCM 2CH

2. The EDID selection will only be activated when the unit is re-plugged

and powered on.

② CAT6 OUT: Connect the CAT6 output of the transmitter with the CAT6

input of the HDMI over single CAT6 receiver.

Note: A. This system was tested with CAT6/23AWG/UTP/568B cables,

so if using cables of another type, results may vary.

B. Cable distance tested with PS3 120G & 40" Samsung LED 12 bit LCD

TV.

C.The figures provided in this manual are for reference only; actual

performance may depend on the source and display used along

with the type cable.

CH-1107TX

EDID

10 Bit

TV/STD

8 Bit

12 Bit

①

CAT6 OUT

②