Ashdown AA-50R Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wzmacniacz Ashdown AA-50R. Ashdown AA-50R 10 stron.

Ashdown AA-50R Podręcznik użytkownika
AA-50R & AA-100R
LO-TRIM / HI-TRIM
The HI and LO trim controls have been provided to 'Trim' the sound from
the instrument / pick up combination to achieve a flat response prior to
any tailoring of the sound with the graphic or pull shape facilities. These
controls may also be used as EQ controls to adjust the top and bottom
end of the instrument sound. Do not boost the LO-TRIM excessively as
this will have the effect of increasing the chances of lowfrequency feed-
back.
CHANNEL 2
Channel 2, the LOW Z or LOW IMPEDANCE channel has two inputs,
one being a jack and the other a female XLR socket. These are both low
impedance, balanced inputs. A mono jack plug may be used in the jack
input for an unbalanced signal connection if required.
These inputs are for use with pickups that offer a low impedance,
balanced output. The jack input may also be used for a second ACTIVE
instrument if required. The XLR input is suitable for use with a micro-
phone for amplifying acoustic guitar, other acoustic instruments or vocals.
Phantom powering ( 48V ) is available with the switch next to the XLR. The
phantom power is ON when the switch is IN. Only use this if you have a
capacitor microphone that requires external phantom powering.
INPUT GAIN - SIGNAL LEVEL INDICATION
Set the INPUT GAIN control of channel 2 in the same way as for
CHANNEL 1.
USER GUIDE
AA-50R & AA-100R
GRAPHIC EQUALISATION
The five bands of graphic equalisation offered have their centre frequen-
cies chosen specifically to suit acoustic instruments and may be used to
adjust the overall sound of the amplifier. Avoid extreme settings on any
slider as these are unlikely to give useful results. Also avoid boosting the
100Hz slider too much as this will tend to increase the chances of low
frequency feedback.
DIGITAL EFFECTS
The 24 bit Digital effects board built into the Ashdown Acoustic amplifiers
uses a 16 way rotary PROGRAM switch.
NOTCH FILTER (ANTI FEEDBACK)
All models in the Ashdown Acoustic series include a NOTCH FILTER that
can be switched IN and OUT. This is included as an anti-feedback device
to allow amplification of an acoustic instrument (particularly acoustic gui-
tar) without trouble from feedback caused by the resonance of the body
of the instrument.
USER GUIDE