CYP CH-1507RX Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik CYP CH-1507RX. CYP CH-1507RX 13 stron. Hdmi to cat5e/6 with lan/ir/rs-232/poe

6.2 Receiver Front and Rear Panels

Front

HDMI OUT

HDMI Out: Connect to a HDMI equipped TV/monitor for display of

the HDMI input source signal.

LAN: Connect to a PC or Laptop to the Internet or network

connection.

RS-232 Out: Connect to the device that is to be controlled (via

D-Sub 9 pin female cable) by RS-232 commands.

Power LED: This blue LED will illuminate when the device is

connected to a power supply.

IR 2 Blaster: Connect to the supplied IR Blaster cable for IR signal

transmission. Place the IR Blaster in direct line of sight of the

equipment to be controlled.

IR 1 Extender: Connect to the supplied IR Extender cables for IR

signal reception. Ensure that remote being used is within the direct

line-of-sight of the IR Extender.

Link LED: The yellow LED will illuminate when both the input source

and output display signals are connected through CAT cable.

When it blinks regularly it states the display is NOT sending signals to

receiver but the transmitter and receiver are linked and if it blinks

irregularly it states and error has occurred.

CAT5e/6/7 In: Connect to the Transmitter unit with a Single

CAT5e/6/7 cable for transmission of all data signals.

Receiver

RS-232 OUT

CAT5e/6/7 to HDMI with LAN/IR/RS-232

Rear

POWER

IR2

BLASTER

IR1

EXTENDER