Ashdown ORIGINal VALVE PRE Podręcznik użytkownika - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Pedał muzyczny Ashdown ORIGINal VALVE PRE. Ashdown ORIGINal VALVE PRE 10 stron.

USER GUIDE

ASHDOWN ORIGIN

VALVE PRE AMP PEDAL

Shape

The shape Button when engaged provides a broadband mid scoop and is applied to the signal

Before the Drive circuit or EQ.

The Equalisation circuit has 5 bands with the control frequencies centred around 100Hz , 340Hz,

680Hz, 1.6KHz and 7KhZ. The associated filters are of a low Q type and therefore there is consid-

erable overlap between frequencies, which ensures a smooth response. Since the pedal has been

designed to be used with other equipment such as mixers and amplifiers etc. which will invariably

have more on board Equalisation the control range has been tailored accordingly.

Output

The output control controls the signal from the pedal to the connected equipment via the ¼"

JACK socket. When this output is in use the Phones output is unavailable. This jack socket has a

PERMANENT ground. Adjust the output level to suit the connected equipment. NOTE that this

control does NOT adjust the DI output This control also functions as the VOLUME control for the

inbuilt headphone amplifier. Headphones can be connected on the rear panel via the 3.5 mm 3

pole MINI Jack.

Line Mix

The Line Input is located on the rear panel below the PHONES out, this is again a 3.5mm MINI Jack

the level control is used to mix the line signal with that from the instrument. Various signal sources

can be connected here by the use of suitable leads which are commercially available 3.5mm Mini

Jack to RCA phono will enable you to connect to CD and Video players and the recording out of

many small mixing desks 3.5 mm mono Mini Jack to ¼" Jack will enable you to connect into the

fold back of most mixing desks. 3.5MM to phone Jack will enable you to connect to most phones

and players for music.

It's Showtime!

Showtime is basically the overall Mute button the pedal lights up RED when unmuted and ready to

play Note That the LINK socket on the rear panel remains Active whilst in mute mode. This output

is at instrument level and can be used to drive a tuner for example .It is therefore possible to tune

up without any signal to the PA or other connected equipment.