CYP PU-1107-KIT Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przedłużacz CYP PU-1107-KIT. CYP PU-1107-KIT 16 stron. Pure digital hdmi over single cat6 extender set, repeatable version
Również dla CYP PU-1107-KIT: Instrukcja obsługi (12 strony)
Drukuj stronę6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter Front and Rear Panels
HDMI INPUT
1
1
HDMI INPUT: Connect to the HDMI or DVI output port of your source
equipment such as a DVD/Blu Ray player or Set-top box with an HDMI
cable or link up with another compatible receiver unit to extend a
signal over long distances.
2
DC 5V: Connect the 5V DC power supply to the unit and plug the
adaptor into an AC outlet.
3
EDID Control Switch: Switch the EDID between STD and TV modes.
Switch to STD mode to use the unit's built-in EDID settings or switch
to TV mode to use the TV/display's EDID settings. The default factory
setting is TV, leave as is when the display is working properly.
Note: 1. When EDID is switched to STD the unit will use its built-in EDID
settings which support:
Video → 1080p 8-bit, 10-bit or 12-bit (max)
Audio → PCM 2CH
2. The EDID selection will only be activated when the unit is power cycled.
4
8/10/12-Bit Switch: Switches between 8, 10 or 12-bit modes.
5
CAT6 OUT: Connect the CAT6 output of the transmitter to the CAT6
input of the receiver.
8
DC 5V
2
CAT6 OUT
EDID
10 Bit
TV/STD
8 Bit
12 Bit
3
4
5