Ashford Katie Table Loom Instrukcje - Strona 2

Przeglądaj online lub pobierz pdf Instrukcje dla Tkanie Ashford Katie Table Loom. Ashford Katie Table Loom 3 stron. A folding 8 shaft 30cm (12ins) table loom
Również dla Ashford Katie Table Loom: Instrukcje (3 strony)

Drukuj stronę

Step 4: Loosen knobs securing the beater supports, slide the

beater completely forward and tighten the knobs.

NOTE: To avoid potential damage to the top beater rail we have

packed it separately. Please attach it to the beater arms with 2 x bolts,

washers and wing nuts. Make sure the wing nuts are parallel to the

beater rails to ensure the loom folds.

Step 5: Tie a knot in the ends of the bungee cords and thread them

through the holes in the beaters. Tie a knot in the other end

and locate them into the slots in the castle front. Adjust the

position of the knot to increase or decrease the tension.

Step 6: Push the levers down and check the gap between the shafts

and the castle top is approx. 1cm (½ins) on both sides. Adjust the

height as necessary by moving the Texsolv cord in the lever or on the

screw head in the shaft end.

Ashford Handicrafts Ltd.

Factory and Showroom: 415 West Street,

PO Box 474, Ashburton, New Zealand

Telephone 64 3 308 9087

Facsimile 64 3 308 8664

Email: [email protected]

Internet: www.ashford.co.nz

Step 7: Attach the front and back warp sticks with the cotton string

supplied with your loom as illustrated.

Front

beam

Step 8: To fold the loom, lift all the levers and reverse steps 4, 3, 2

and 1.

Warping Instructions: Refer to the Learn To Weave on the Table

Loom Booklet. Please note the weaving project in the booklet is for a

project on a 40cm (16ins) four shaft loom. For a project on the Katie

Table Loom please start with the project notes enclosed.

IMPORTANT

When you need to advance your weaving, only advance it so the fell

(the edge of the weaving at the last weft pick) is level with the legs. If

you advance it too far your beater will hit the bottom roller.

1cm (½in)

Recommended Accessories:

Raddle Kit 30cm (12ins)

Warping Frame – either 11m (37ft) or 4m (14ft)

Other Accessories:

Boat Shuttle 29cm (11ins), Boat Shuttle 35cm (14ins)

Boat Shuttle Bobbin Winders Wood and Metal

Stick Shuttles

Stainless Steel Reeds - 6, 8, 10, 12 and 16 DPI

Texsolv Heddles - Bundles of 40 or 100