Cloud PM1 Instrukcja instalacji i obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Mikrofon Cloud PM1. Cloud PM1 16 stron. Paging microphone

Installation

Connections to the PM1 are made via two 3-way screw-terminal connectors on the

internal PCB. Two cut-outs are provided at the rear of the base moulding for cable

access; these can accommodate cables up to 9 mm diameter. A single 2-pair cable

(with an individual screen for each pair) provides the neatest finish, though using two

separate cables for the audio and access connections is perfectly acceptable

(see page 11 for information regarding use of 2-pair cable).

To access the internal connectors, turn the microphone upside-down and remove the

five self-tapping screws securing the steel baseplate to the moulded plastic base (item

in the baseplate diagram on page 7). Gently remove the baseplate from the base

moulding; be careful not to strain the internal mic capsule cable.

If using two separate cables, the audio cable should be a good quality, two-core,

screened microphone cable. The cable should be fed through the left-hand of the

two cable clamps (looking from the rear of the unit), and connected to the left-hand

screw-terminal block (marked AUDIO) on the internal PCB.

Connect to the terminal block as follows:

TERMINAL

USE

TYPICAL CABLE COLOUR

Hot

Phase (+)

Red

Cold

Anti-phase (-)

Black

Screen

Screen (Scn)

Screen

The other end of the audio cable should be connected to a suitable microphone

input on the host mixer (or zoner). Consult the Installation Guide for the mixer

to confirm the most suitable method of connection. It may also be necessary to

configure the microphone input for use with a paging microphone. As all recent

Cloud mixers and zoners are designed with this application in mind, connection to

them is straightforward.

The maximum cable run over which the microphone will operate satisfactorily is a

function of the cable quality, the design of the host mixer's input stage and the level

of electrical noise present in the installation environment. As rough guidance, with

professional-quality mic cable and a Cloud mixer, 100 m should present no problems.

PM1 Installation and User Guide v1.0