Dolmar 111i Instrukcja serwisowa - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Piła łańcuchowa Dolmar 111i. Dolmar 111i 19 stron.

DOLMAR GmbH

04 Ignition system

04-01 Checking the spark plug

Unscrew the spark plug (1) and connect it to

the spark plug terminal (2). Hold the spark

plug against cylinder ground and withdraw the

starter rope (3). If no spark is generated,

repeat using new spark plug.

04-02 Replacing the spark plug terminal

Remove the hood (07-01) for removing the

spark plug terminal. Using a pair of pointed

pliers hold the spring (7) of the plug connector

and pass the rubber cap (5) towards the rear

over the ignition cable (6).

04-03 Replacing the short-circuiting switch

To remove the short-circuiting switch (8) first

remove the filter hood, carburettor and bottom

part (07-06).

crew the nut (10) and withdraw the switch from

the short-circuiting cable.

Uns-

04-01 Checking the spark plug

Clean or renew contaminated or defective

spark plugs.

04-02 Installing the spark plug terminal

First pass the rubber cap (5) over the ignition

cable. Then engage the spring (7) in the

existing hole of the ignition cable. In case of

new ignition cables, press in the tip of the

spring (refer to arrow).

04-03 Installing the short-circuiting switch

Push the short-circuiting cable (11) into the

switch and install the rubber cap (12) in place.

Install the switch in the crankcase ensuring

that the flat side faces upwards. Screw on nut

(10) with the toothed side facing the housing.