Ashly TRA-Series Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Ashly TRA-Series. Ashly TRA-Series 13 stron. Tra-series
Również dla Ashly TRA-Series: Instrukcja obsługi (12 strony)

Ashly TRA-Series Instrukcja obsługi
Operator Manual – TRA Series Amplifiers

Typical Applications

TRA-Series amplifiers offer many output options. In this illustration, the 4-channel
amplifier is receiving two stereo signals and is driving two pairs of stereo speakers.
TRA-Series amplifiers are specifically designed to drive 70V or 100V constant voltage
(CV) lines. This illustration shows a 2-channel TRA driving two 70V CV lines. Always
make sure that the total wattage draw from all the speakers on a CV line does not exceed
the rated output of the channel to which they are connected.
Connectors & Polarity
TRA-Series amplifiers utilize two types of professional audio connectors. For the inputs
3-pin Euroblock connectors are utilized with their polarity clearly marked on the
amplifier's rear panel. Outputs are via screw terminal connectors. The polarity for these
connectors is also clearly marked on the unit's chassis.
NOTE: It is possible to simultaneously drive loads connected to the 8/4 ohm output
AND the, 70/100 volt outputs of a particular amplifier channel. However, care must be
taken to ensure that the combined load is not less that the 4 ohm maximum. If you are
unsure as to how to determine the combined load, please contact Ashly.
All Rights Reserved
Page - 7
Important Safety
Instructions – 2
Introduction - 3
The TRA Series - 4
Physical Description - 5
Installation – 6
Requirements
Typical Applications
Connectors & Polarity
Operation - 8
Troubleshooting - 9
Spec Table - 10
Dimensions - 11
Warranty - 12
Rev 1.2 0306