Ashly WR-4 Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pilot zdalnego sterowania Ashly WR-4. Ashly WR-4 3 stron. Active remote

Drukuj stronę
To program the output channel whose volume and source selection will be
controlled by the WR-4:
1. Simultaneously press select keys two and six to enter the OUTPUT CHANNEL
CONTROL PROGRAMMING MODE. The second select LED will start flashing indicating
it is in the Output Channel Control Programming Mode.
2. The number displayed in the numeric LED display is the output channel of the
24.24M that the WR-4 will control. Simply scroll the up and down arrow keys to
change the output channel that the WR-4 will control.
3. Press select keys two and six together again to accept the output channel number
and return to normal operating mode.
4. The output channel volume control feature of the WR-4 can be disabled by switching
the rear-side red switch number two to ON.
To program the sources which will be selected when each select key is depressed:
1. Simultaneously press select keys three and six to enter SOURCE SELECT
PROGRAMMING MODE. The select LED of the current select button will start flashing
indicating the unit is in the Source Select Programming Mode.
2. Press any one of the six select keys to begin programming the input channel sources
to be selected by that source select key. The corresponding select LED will start
flashing indicating the WR-4 is in programming mode of source selection for that
key.
3. Press the up and down arrow keys to scroll through the input channels. If an input
channel is assigned to be selected by the currently flashing select key, then the input
channel number will be flashing on the numeric LED display. To select or deselect an
input channel assigned to the source select key, simply press the currently flashing
select key.
4. Press both the up and down keys together to accept the source select assignments
and return to the normal operating mode.
5. Programming modes can be disabled from being activated from the front panel keys
by switching the rear-side red switch number one to ON.
To program the options applied to the WR4:
Options Available
Exclusive source selection (when a source is selected all others are turned off)
•
Biamped operation – both the current channel and the next channel will be adjusted
•
when this option is enabled.
Programming Instructions
1. Simultaneously press select keys four and six to enter the OPTION PROGRAMMING
MODE. The fourth select LED will start flashing indicating it is in the Option
Programming Mode.Press the up or down keys to change options.
2. Press the fourth select key to turn on or off an option. If an option is turned on the
displayed option number will flash.
3. Press both the up and down keys together to exit the programming mode.
Lockout Functions:
Programming Modes may be locked out so they cannot be inadvertently modified by
switching Switch 1 (on the Back of the WR4) to the On Position
Ashly Audio Inc.
internet: http://www.ashly.com
847 Holt Road
Webster, NY 14580
(585) 872-0010
(800) 828-6308
fax: (585) 872-0739