Dolomite Mitos Instrukcja programowania - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja programowania dla Pompa wodna Dolomite Mitos. Dolomite Mitos 15 stron. Automated product collector
Również dla Dolomite Mitos: Skrócona instrukcja obsługi (3 strony)

Drukuj stronę

The Dolomite Centre Ltd.

Command Description

Response "#A0"

If pump does not receive any command, e.g. a status query "s", for 30 seconds it will

automatically return to manual mode.

Your application sends this to move the pump

out of ERROR state and back into IDLE. C will

also stop control and force the pump back to

IDLE.

You must explicitly clear all error conditions.

This ensures your application has noted the error

and corrected it. The ERROR state will not clear

unless any physical error condition has been

corrected.

Returns text string of the last error message.

This may a P-Pump specific error or an error

from the underlying micro controller board.

Note, this command will always return the last

error message no matter how old. The message

is only valid when the pump is in the ERROR

state. See section 6.4 below, Error codes, below

Returns two strings: date and error information

separated by <LF>.

"Lpump Z" sets display name on the pump to

"pump Z". The label is limited to a max of 8

characters - alphanumeric plus underscores.

Name will be upper case only.

Lower case L.

Returns current label on the pump,

e.g. "#lpump Z"

Returns the serial number for the pump,

e.g. "#n160295"

Send "Tx" where x is UTC time in seconds since

1/1/1970

Responds "#txxxxxx" where xxxxxx is UTC time in

seconds since 1/1/1970

Replies with "#sErr,Sp,Src,Pc,Ps,Pt,Qc,Qt,Ft", see

section 6.3, Status command response, below

for details.

"P1000" sets target pressure to 1000 mbar and

starts control. Replies "#P0" and starts pressure

control if in remote control mode (see A1).

Setting target pressure to 0 (sending the "P0"

command) moves the pump to the IDLE state. It

means the pump stops controlling pressure and

opens the vent valve.

3600051 - P-Pump API - programming instructions - v 1.3

Pump State

Control Mode

(before after)

ERROR

IDLE

(ANY

IDLE)

ANY

[response

only

guaranteed

valid if in

ERROR state]

IDLE

Remote

ANY

IDLE

ANY

ERROR IDLE

IDLE

CONTROL,

CONTROL

REMOTE

CONTROL

or CONTROL

IDLE

Page 8 of 15