Dolphin BC 2012 Podręcznik użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Suszarka Dolphin BC 2012. Dolphin BC 2012 12 stron. Automatic velocity hand dryer

Drukuj stronę

Safety & Guidance notes

Important:- Read all these instructions before commencing the installation.

All wiring of this hand dryer should be in accordance with the current IEE regulations, or the

appropriate standards in your country.

This hand dryer MUST be installed by a suitably qualified person.

Ensure that the mains supply (voltage, frequency, and phase) complies with the hand dryers

rating label.

This appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they have been

given supervision or instruction concerning use of the appliance by a person responsible for

their safety.

Children should be supervised to ensure that they do not play with the appliance.

Do not allow hand dryer to get excessively wet.

Do not modify and disassemble the unit unnecessarily.

The hand dryer should be provided with a fused spur, isolator switch capable of disconnecting

all poles, having a contact separation of at least 3mm.

Ensure the hand dryer is properly earthed

Always use the hand dryer with the drain tank & air filter provided.

We recommend installing a RCD (residual current device) use a single phase 220-240V 50Hz

cable with a 20A rated current, 15mA-type rated operating current.

Do not let children hang from the hand dryer

Wear gloves when inspecting and cleaning the unit.

If the supply cord is damaged, it must be replaced by a suitably qualified service engineer in

order to avoid a hazard.

For additional protection, the installation of a residual current device (RCD) having a rated

residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the

dryer.

Do not use the hand dryer in the following places:-

Where the ambient temperature is below -10°C or above 40°C

Where the hand dryer may come into direct contact with water

Where the unit is under direct or strong sunlight

Where condensation may form within the unit.

Locations where corrosive, neutral, or reductive gases are present.

Features

"No touch" hand drying ensures complete hygiene.

Economical high speed drying only "10 seconds"

Built in tamper-proof timer function

Fitted with HEPA air filter to remove dust and bacteria.

2 speed & 2 heat settings

Anti-bacterial coating

Built in UV sterilization function

Specifications

Rated voltage

Input power

Air velocity

Heating power

BC 2012 User Manual

220-240V ~

1650 – 2050W

95 m/S

1000 – 1200W

Motor

Induction method

Protection class

Dimensions

Net weight

Brushless Dc motor

IR blocking

IPX4

300x215x700

9.5kg