EG Athens 350MD Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Rower EG Athens 350MD. EG Athens 350MD 9 stron.

INSTALLATION INSTRUCTIONS

1. Unpack the bicycle from the box and cut all the ties that held the bicycle together during

shipping.

2. Install the handle bar by inserting the handlebar stem into the head tube. An Allen key is

supplied to install the handle bar stem.

3. Adjust the handlebar by loosening the nut holding the handlebar and then re-tightening it with

the included Allen wrench.

4. ! WARNING: Do NOT over tighten nut against the fork; for you will risk damaging your

suspension fork.

5. The front and rear LED/reflector run on the main Li-on battery, and is operated via the light

button on the handlebar display unit.

6. Install the pedals to the bike. Each of the pedals has a letter indicating which side it needs to

be installed to. R=Right and L=Left. Install them using the provided wrench.

7. ! WARNING: Before riding the bicycle ensure the main Li-on battery is properly installed and

locked in before riding the bicycle. If the Battery is not firmly locked onto the rear rack, it may

slide off the rack and cause damage to the battery.

8. Insert the battery into the rear rack and lock in your battery with provided key. Ensure that the

rails are properly aligned below the battery. Ensure that the battery is locked in by lightly

tugging on the battery to ensure it will not slide out.