Blueprint Subsea Seatrac x110 Instrukcja aktualizacji - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja aktualizacji dla System bezpieczeństwa Blueprint Subsea Seatrac x110. Blueprint Subsea Seatrac x110 10 stron. Upgrading beacon firmware

Drukuj stronę

•

If programming still fails, ensure that a screened serial communications cable is used, and both the

Beacon and PC are located away from any sources of electrical interference that may be corrupting the

data messages.

3.1. Resetting to Defaults

If you are having trouble connecting the programmer to the beacon, and you are sure the Beacon has power and

is connected to the correct serial port, it may be that you have changed the Beacon's serial communication baud

rate (speed) setting.

This setting is stored within the Beacons permanent memory, and can be reset to the factory default value of

115200 baud by the following procedure...

Please note that resetting the Beacon to default will loose all user settings and calibration data. Please

refer to the Beacon's user manuals for details on how to reset and recalibrate the hardware.

To reset the Beacon to factory defaults...

•

Turn on the power to the Beacon and check it has booted into the main application – the status LED on

the base of the Beacon housing should be flashing Green.

•

Hold the "reset magnet" over the magnetic sensor at the base of the Beacon (see Beacon user manual

for details).

•

As the magnet is moved into place, the Green status LED should start quickly flashing Red to show the

presence of the magnet.

•

Hold the magnet in place for 5 seconds until the status LED stops flashing, and become permanently

illuminated red. At this point the defaults have been applied.

•

Cycle the power to the beacon to ensure the new communications and some of the calibration settings

are re-applied to hardware.

3.2. Bootloader mode

On power-up the Beacon will start its Bootloader application firmware, initialise hardware then start the main

application firmware running.

However, if power was interrupted during the 'update' stage of the programming procedure, or another issue has

caused this firmware to become corrupt, then the main application may fail causing the beacon to freeze and

become unresponsive.

Activating 'Bootloader Mode', prevents the Bootloader firmware from starting the main application, and as the

Bootloader application is stored in a separate part of memory to the main firmware, it is unlikely it will have been

corrupted.

To activate Bootloader mode...

•

Turn off the power to the beacon,

•

Hold the "reset magnet" (south pole) over the magnetic sensor at the base of the Beacon (see Beacon

user manual for details).

•

Power up the beacon keeping the magnet in place. The Beacon's status LED should stay flashing red.

SeaTrac

Upgrading Beacon Firmware