Askey WLU6111-D69 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Jednostka sterująca Askey WLU6111-D69. Askey WLU6111-D69 8 stron. 802.11b/g/n module

Canada. Industry Canada (IC)

This device complies with RSS210 of Industry Canada.

CAUTION:

Exposure to Radio Frequency Radiation. The installer of this radio equipment

must ensure that the antenna is located or pointed such that it does not emit RF field in excess of

Health Canada limits for the general population. Consult Safety Code 6, obtainable from health

Canada's website www.hc-sc.ca/rpb.

1. This Transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled

environment.

3. Any changes or modifications (including the antennas) made to this device that are not

expressly approved by the manufacturer may void the user's authority to operate the

equipment.

This device is intended only form OEM integrators under the following conditions:

1) The transmitter module may not be co-located with any other transmitter or antenna.

IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop

configurations or co-location with another transmitter), then the FCC authorization is no longer

considered valid and the FCC ID can not be used on the final product. In these circumstances, the

OEM integrator will be responsible for re-evaluating the end product (including the transmitter)

and obtaining a separate FCC authorization.

End Product Labeling

The final end product must be labeled in visible area with the following:

Contains TX FCC ID: H8N-WLU6111; IC: 1353A-WLU6111

End Product Manual Information

The user manual for end users must include the following information in a prominent location

"IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna

must not be co-located or operating in conjunction with any other antenna or transmitter.

Operation is subject to the following two conditions: (1) this device may not cause interference,

and (2) this device must accept any interference, including interference that may cause

undesired operation of the device.