EGAmaster EGATRONIK 58516 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt testowy EGAmaster EGATRONIK 58516. EGAmaster EGATRONIK 58516 18 stron. Tester

8. Do not assume neutral ar ground wire is safe to touch. lncorrect or poorly connected circuits

may cause wires to be charged.

9. When low battery indication appears, please replace the batteries.

10. When using the detector, please only hold up to the line befare the translucent sensing part

and not over.

11. Comply with local and national safety regulations and requirements.

12. The detector will not detect any voltage if:

- The wire is shielded.

- The operator is not connected with the ground ar isolated from an effective ground.

- The voltage is DC.

13. The detector may not detect any voltage if:

- The operator does not hold the detector.

- The operator is wearing gloves.

- The wire under test is partially buried ar in a grounded metal conduit.

- The magnetic field generated by the voltage source is blocked, suppressed or interfered

with.

- The frequency of the voltage being detected is nota perfect sine wave and may be distorted

by harmonics.

- The detector is used outside of the operating specifications (see Technical Specifications far

details).

lt is applicable to test and measuring circuits connected at the source of the

CAT IV

ELECTRICAL SYMBOLS

Protected throughout by Double insulation ar Reinforced insulation

Caution, possibility of electric shock

Warning! Refer to the manual

In compliance with the directive of European Union

Conforms to UL STD 61010-1, 61010-2-030

Certified to CSASTD C22.2 No. 61010-1, 61010-2-030

building's low-voltage MAINS installation

Alternating current