Bluerock Tools SDS200 Podręcznik operacyjny - Strona 14

Przeglądaj online lub pobierz pdf Podręcznik operacyjny dla Sprzęt czyszczący Bluerock Tools SDS200. Bluerock Tools SDS200 17 stron. Sectional drain cleaning machine

Drukuj stronę

S D S 2 0 0

P I P E

D R A I N

Troubleshooting

SERVICING SHOULD ONLY BE DONE BY A QUALIFIED TECHNICIAN.

DON'T FORGET TO UNPLUG POWER TO UNIT PRIOR TO SERVICE!

PROBLEM

CAUSE

Motor does not

Machine unplugged

start

Fuse blown

Capacitor blown

Bad on/off switch

The cutters will not

Cutting blade is dull

cut

Cutter is damaged

Too much force being applied

Cable is not

Main channel is rusted

turning

Clutch is worn down

Handle not pressed down all the way

The cable spins,

This is a non-automatic forward/reverse drain

but does not move

cleaner. This is a sectional type drain cleaner.

forward or reverse

It does not go in and out automatically

Damaged Cable

Dull cutters

Cutters not assembled in correct sequence

Low quality pipe

Bad quality or insufficient thread cutting oil

Pipe turns while

3-jaw clutch not tight

threading

3-jaw clutch teeth dirty

3 jaw clutch teeth damaged or dull

Cable broken in the

Incorrect operations

Pipe

Prolonged use in "L" Reverse

Cable is stuck

Pipe has many turns and is very long

Cable will not cut

Blockage too hard

through blockage

Complicated path to the blockage

C L E A N E R

Note

CORRECTION

Plug into power source

Replace the fuse

Replace capacitor

Replace Switch

Replace or sharpen blade

Replace cutter

Cut slower

Take apart and remove rust

Replace clutch

Engage clutch handle down all the way

Consult the operating manual for procedures on

standard operating procedures

Replace cutters

Put cutters in correct sequence

Make sure only pipe of good quality is used

Use only thread cutting oil in adequate quantity

Tighten handwheel clutch

Clean with wire brush

Replace 3-jaw clutch

See operational protocols. Get drill with helical

shaft and extension to collect the broken cable

Increase push/pull force during operations

Change direction/angle of the cable

Gently push and pull the cable rotating

clockwise. Have patience, sometimes

obstructions take a while to clear

Use a different set up, smaller or larger. Operator

experience comes into play on this

Find a shorter route to the blockage

Chapter