Asko D3250FI Instrukcja instalacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Zmywarka Asko D3250FI. Asko D3250FI 12 stron. dishwaher

Drukuj stronę

CONNECTING THE ELECTRIC CABLE

If the cord is not long enough, or if a hard-wire

installation is needed, follow the steps below to

complete the electrical connection.

WARNING! Before starting this procedure, be sure

the power is turned off at the breaker/fuse box.

Connect supply cable with

a UL-listed strain relief

bushing (if nonmetallic

cable is to be used).

Connect branch circuit

white lead to N lead on filter.

Connect branch circuit

black lead to L lead on filter.

CONNECTING THE WATER SUPPLY

In order to prevent heat damage to the inlet valve, all

solder connections must be made before the water

supply line is connected.

Flush the water supply line prior to connecting it to the

water fill tube.

The unit has a float switch in the base pan to protect

against flooding. If the inlet valve connection is not

seated properly, water may leak into the base pan and

activate the float switch.

It is important that the water supply line and the shut-off

valve have a sufficient flow volume. At last 3 gallons (12

liters) per minute must be able to pass through the

line. The water pressure should be 18-176 psi.

TESTING FOR LEAKS

1. Turn on the water supply and check for leaks.

2. Turn the power on at breaker/fuse box and test the

dishwasher operation by running a Rinse cycle.

(This should take about four minutes.)

3. Turn off the electrical power and check for leaks

Page 8

Connect ground wire to ground connection screw

on the bottom.

NOTE:

When doing a hard-wire installation, you must

remove the supplied power cord.

(1) Water supply

(2) Water supply valve

(not supplied)

NOTE:

Be sure to run the PEX tubing through the hole

to sink compartment before moving the

dishwasher into position.

under the dishwasher and sink.

4. Make sure that no kinks have developed in the drain

lines.

If there are no leaks and the dishwasher seems to be

working properly, continue with the installation.