Ambery RFDM2?PBG Podręcznik użytkownika - Strona 8
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Tuner TV Ambery RFDM2?PBG. Ambery RFDM2?PBG 9 stron. Coax a/v agile demodulator tuner w/ir remote control
Drukuj stronęVHF/UHF Setup
The default setting for our RFDM2 is for CATV channel range. To reset RFDM2 unit for
VHF/UHF air TV channels. Please follow the steps below:
1. Power on the RFDM2 unit first. The LED screen on the front will display the system
status in "nC" or "nA". The factory default of each RFDM2 is set for "nC".
nC : standing for CABLE cannel system
nA : standing for AIR channel system
2. Press and hold the CHANNEL Down button for 10 seconds (do not release the
button). Wait until the LED digit screen starts to flash, then release the button.
3. Once the LED screen starts to flash, RFDM2 unit will display "01" flashing
alternatively, which means that the unit is ready for new setup.
At this time please press the CHANNEL Down or CHANNEL UP button from the front
panel to adjust change the value on the LED screen. There will be only two, "01" and
"02".
01 for "nC" >>>>>>>>>>>> CABLE TV System
02 for "nA" >>>>>>>>>>>> VHF/UHF, Air TV Channels for analog antenna
4. After the adjustment, press and hold the CHANNEL Down button for 10 seconds or
wait until the LED digits stops flashing, then release the button.
5. Power off the RFDM2 unit and plug the power supply back on again to confirm if the
new setting is effective and displaying "nA" for the new system status.
7