eGeeTouch GT2002 Skrócona instrukcja obsługi
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Zamki eGeeTouch GT2002. eGeeTouch GT2002 2 stron. Smart padlock
Drukuj stronę
Using external USB to power up the lock
eGeeTouch survives over 2,000 locking/unlocking cycles. It notifies you
when battery run low through your smartphone & blinking LED. When
batteries finally run out, use a standard external USB power source (e.g.
from your Laptop PC or USB power bank) to power up your smart lock,
and then proceeds with unlocking and to replace batteries.
USB power source does NOT charge batteries of the lock.
Warranty
eGeeTouch® smart padlock is warranted to the original purchaser to be free from defects in
workmanship and material. JSB Tech Pte Ltd, will, at its option, repair or replace any defective
part which may malfunction under normal and proper use within a warranty period of 1 (one)
year from the date of purchase. This one year warranty clause is NOT applicable to European
Union (EU) member states. Purchases made in EU member states will be covered by the existing
consumer laws across the European Union, which provide statutory warranty rights in addition
to the coverage of one year warranty period. The foregoing warranty shall not apply to defects
resulting from misuse, abuse or transfer by the Buyer, Buyer-supplied software or interfacing,
unauthorized modification or operation outside of environmental specifications for the product.
JSB Tech Pte Ltd does not warrant that the operation of the instrument software, or firmware,
will be uninterrupted or error free.
The exclusive remedy under any and all warrants and guarantees, expressed herein, and we shall
not be liable for damages from loss or delay of equipment uses, consequential, or incidental
damage. No other warranty is expressed or implied. JSB Tech Pte Ltd specifically disclaims the
implied warranties of merchantability and fitness for a particular purpose.
Limitation of Liability
In no event shall DIGIPAS TECHNOLOGIES INC., (hereinafter, "the Company") be liable to you or
any third party for any indirect, special, incidental, exemplary or consequential damages of any
kind resulting from any breach of warranty or from the performance or use of the product. This
includes without limitation: property damage, loss of value of the product or any third party
products that are used with the product, or loss of use of the product or any third party products
that are used with the product, even if the Company has been advised of the possibility of such
loss or damages. The Companyʼs total cumulative liability arising from or related to the product,
whether in contract, tort (including negligence) or otherwise, shall not exceed the amount
actually paid by you for the product. Some states and/or jurisdictions do not allow the exclusion
or limitation of incidental or consequential damages, so the above limitations or exclusions may
not apply to you. If any limitation of liability shall be deemed invalid by any applicable law, then
the limitations of liability set forth above shall apply to the maximum extent permitted under
applicable law.
Support
You can find a complete Troubleshooting Guide, Demo Videos
& FAQ online at www.egeetouch.com/support.
Distribute by:
Manufactured by : JSB TECH Pte Ltd
DIGIPAS TECHNOLOGIES INC.
www.egeetouch.com
200 Spectrum Center Drive, Suite 300
Irvine, CA 92618
JQC-5-02002-94-006
SMART PADLOCK
QUICK START GUIDE
U.S Pat. No.: US 9,121,199 B2 & D 722,485 S
Model GT2002
This Quick Start Guide contains only the basic & essential information in consideration
of the environment. A complete guide is available online in softcopy at
www.egeetouch.com/support
Product overview
Technical Specification
Shackle Diameter
Shackle Vertical Clearance
Shackle Horizontal Clearance
Power
Operating temperature
Storage temperature
Note: Product specifications are subjected to change without prior notice
1. Shackle
2. USB 2.0 Port for emergency power
3. Battery Cover
4. Body
5. LED Indicator
6. NFC Receptor Area
: 8.6mm
: 33mm
: 35mm
: A76/LR44 Battery 1.5V (2 Pcs)
or USB external source (backup)
: -10°C ~ 50°C
: -20°C ~ 60°C