d&b audiotechnik Z5330.001 Podręcznik - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik dla Wzmacniacz d&b audiotechnik Z5330.001. d&b audiotechnik Z5330.001 14 stron.

3.3.3 4 CH OUTPUTS - NL8

NOTICE!

The 4 CH OUTPUTS connectors are only intended as an interface

to a rack panel or to loudspeaker multicores such as d&b

Z5343.xxx and breakout adapters such as d&b Z5347.xxx.

Do not connect any loudspeaker cabinets, neither passive nor

active systems, to the 4 CH OUTPUTS connectors, otherwise there

is a risk of damaging the loudspeaker components or the amplifier.

Each of the 4 CH OUTPUTS connectors represents the 4

CHANNEL OUTPUT of the respective D80 amplifier. Each

connector carries the output signals of all four channels of the

amplifier with the following pin assignment.

1+/— = Channel A pos. / neg. 2+/— = Channel B pos. / neg.

3+/— = Channel C pos. / neg. 4+/— = Channel D pos. / neg.

Please refer to the corresponding channel assignment label above

each connector as shown in the graphic opposite.

3.3.4 6 CH OUTPUTS - LKS 19 F

The 6 CH OUTPUTS multipin connectors (LKS 19 F) are used in

connection with the d&b Z5320.xxx cabling system to allow

efficient system wiring using loudspeaker multicore cables.

Each connector carries the output signal of six amplifier channels.

Please refer to the corresponding channel assignment label above

each connector as shown in the graphic opposite.

d&b Z5330.001 Manual 1.4 en