BlueSky Mast 350G XL Series Skrócona instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Systemy podnoszenia BlueSky Mast 350G XL Series. BlueSky Mast 350G XL Series 10 stron.
Również dla BlueSky Mast 350G XL Series: Skrócona instrukcja obsługi (10 strony)
Drukuj stronę
40
Remove the Guy Leader from the
Primary Guy Ring.
45
7 ft.
IMPORTANT: Slide the Guy Handle towards the mast approx. 7 ft.
Repeat this process on all four primary guy ropes.
(This will help prepare you for Incremental Guying)
49
Make sure the castle cuts on the
poles nest together and there is
no gold insert showing.
54
Helpful Hint: When raising the
mast use your finger to guide the
cable to avoid stack up / jumping.
Do Not Duplicate, Alter, or Copy without the Express Written Consent
of BlueSky Mast, Inc. Copyright 2019 Allendale LLC All Rights Reserved
Quick Reference Sheet - Primary Guying Only
41
Locate the four Primary Guy
Ropes with the red tab next to the
guy clip.
1"
50
Release the cam lock and raise
until one inch is showing below
the cam lock. Lock the cam lock.
55
Lock the Cam Lock. *Use the
Velcro Straps to secure cables
and always monitor guy ropes.
350G XL - Lift Series
DEPLOYMENT
42
Clip the first Primary Guy Rope to
the round hole on the guy ring.
46
Make sure the cam lock is locked
and lower the lift base plate to the
ground.
51
Make sure the cam lock is locked
and lower the lift base plate to the
ground.
56
WARNING:
If at any point the
mast begins to slip while the cam
lock is locked - STOP
Read Manual Before Use
Refer to detailed instructions in the
350G XL Lift Series Manual at all times
43
Walk away for the mast and
unwind ALL of the guy rope off of
the guy handle.
47
Insert a center mast pole onto the
lift base plate.
52
Insert a center mast pole onto the
lift base plate and raise it until it
nests together.
57
Use the 7/16 wrench provided with
the system to make adjustments to
the cam lock.
44
Clip the guy rope into the top hole
of the guy stake.
48
Raise the center mast pole
until it nest together with the
mounting pole.
1"
53
Release the cam lock and raise
until one inch is showing below
the cam lock.
58
Tighten the nut on the cam lock a
quarter turn until slipping no
longer occurs.