BlueSky Mast AL3 Series Skrócona instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Systemy podnoszenia BlueSky Mast AL3 Series. BlueSky Mast AL3 Series 6 stron.
Również dla BlueSky Mast AL3 Series: Skrócona instrukcja obsługi (6 strony)
Drukuj stronęAL3 Lift Series - Deployment Quick Reference Sheet
41
1"
Leave 1 inch of the last center
mast pole showing under the
tripod and lock the cam lock.
46
Then grab the guy rope and
wrap it up and over the front
rope lock.
Do Not Duplicate, Alter, or Copy without the Express Written Consent
of BlueSky Mast, Inc. Copyright 2013 Allendale LLC All Rights Reserved
42
Lower the lift base plate and
insert the Base Pole. Raise until
it nest into the center mast pole.
47
Extend all 4 secondary guy
ropes out and stake them into
the ground.
43
Release the cam lock and lower
the mast to the ground. Lock
the cam lock.
48
Make sure all primary and
secondary guy ropes are
locked.
Read Manual Before Use
Refer to detailed instructions in the
AL3 Lift Series Manual at all times
44
Adjust the primary guy ropes
and make sure the mast is
straight and perpendicular.
49
Drive 2 stakes into the 2 holes
on the lift base plate.
45
Lock the primary guy ropes by
pulling a small amount of slack
in. Continued next step -
50
Deploy the BlueSky Surface
Wire Grounding Kit at this time
(if required).