Asko DW955 Jak korzystać z instrukcji - Strona 15

Przeglądaj online lub pobierz pdf Jak korzystać z instrukcji dla Zmywarka Asko DW955. Asko DW955 17 stron. Asko 1905: user guide

If the machine does not work

If the machine does not work, check to see whether there is some simple fault that you can rectify your-

self. Follow the instructions below. Aslo check page 11, Fault-tracing programme.

Problem

The machine will not start

Water remains in the machine

If the machine should overfill

with water, the outlet pump

will start automatically. If,

however, the water does not

pump out, the fault may be

due to one of these reasons:

Poor dishwashing

performance

Grey film on washed items

Response

1. You have forgotten to press the main switch.

2. The door is not properly closed.

3. A fuse has blown.

4. The power supply plug is not inserted in its socket.

1. Outlet hose kinked Check that the hose is not kinked or sharply bent.

2. The strainers are blocked. Clean the coarse and fine strainer and the filter.

3.Outlet hose blocked. Check that nothing has blocked the hole where the outlet hose is

connected to the sink drain trap. Particles of food can collect as shown in the drawing.

Check, too, that the conical connecting pipe is cut so that the internal diameter is as

large as possible, but at least 18 mm.

Check the following points:

1.That the spray arms are not being prevented from turning by items sticking

down from the upper basket and that the holes in the spray arms are not

blocket by dirt.

2.That the spray arms can rotate freely, and are not being slowed by grit in the

bearings. Spin the arms by hand: if they do not spin freely, lift them off and

clean the bearings and mounts.

3.That the machine is admitting sufficient water. Check the inlet hose for kinks

or sharp bends. Check that the water pressure is sufficient: 0.03–1 MPa (4–

145 PSI).

4.That the correct quantity of detergent has been used: see page 5. Do not use

old or caked detergent. Keep the detergent dry and cool in a closed pack.

Remember that it should be bought and used fresh.

5.That the strainer is properly positioned and is clean (see page 10).

6. That you have chosen a enough strong programme.

A tendency for a grey film to develop on washed items may be due to lime from hard

water. The problem can often be alleviated by using an acidic rinse aid, i.e. one

containing citric acid (low pH value, as shown on the rinse aid label). If the dishwasher

incorporates a water softener, the grey film may indicate that there is no salt left in the

softener. Refill it with salt.