Asko WMC63VACS Instrukcja obsługi - Strona 16
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zmywarka Asko WMC63VACS. Asko WMC63VACS 18 stron. Cleaning machine
Drukuj stronęInstallation instructions
Read these instructions carefully and completely
before you install the machine. The installation
should be carried out by a qualified person who
is familiar with all local codes and ordinances for
electrical and plumbing connections.
Cosmetic damage must be reported to your dealer
within five days from the date of purchase. After
unpacking the machine, thoroughly check the unit
for cosmetic damage.
Leveling the machine
It is important that the machine is level to prevent
excessive vibrations during spin cycles. Each foot
of the machine is adjustable, so you can level the
machine on any surface. Once it is level, securely
tighten the lock nuts on the feet to prevent
excessive vibration during spin cycles.
16
Be sure to
tighten the lock
nuts securely
when you level
the machine.
Customer Care Center
1-800-898-1879
www.askousa.com
Water supply connection
Since ASKO Cleaning machines have a built-in
heating element, you only need a cold water inlet.
The connection should be made by someone who
is sufficiently skilled. Use the hose supplied with
the machine. (The inlet hose is marked for correct
connection.) The water pressure must be in the
range 15–146 PSI. A tap should be fitted on the
water supply pipe. If a new supply pipe has been
installed for the machine, it should be flushed
thoroughly to remove any foreign particles that
might clog the filter in the water inlet.
Drain outlet connection
The machine is supplied with the outlet hose
already attached. The hose should be installed
at a height of 24" to 36" (610 mm to 914 mm)
above the bottom of the unit. (The lower height is
preferable.) Make sure the hose is not kinked.
NOTE!
If the hose is extended, the internal diameter of
the coupling must not be less than ½".
WARNING!
Do not extend the drain hose higher than 36"
(914 mm) from the bottom of the unit.