Asko DOMESTIC TD85 Instrukcja instalacji - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Suszarka Asko DOMESTIC TD85. Asko DOMESTIC TD85 16 stron. Heat pump tumble dryer
Również dla Asko DOMESTIC TD85: Instrukcja instalacji (12 strony)
Drukuj stronę
3. Use the strain relief attached below the terminal
block opening.
4. Loosen or remove center terminal block screw.
6
5. Connect ground (center) wire of power supply
cord to the center, silver-colored terminal screw.
Tighten screw.
6. Connect the other wires to outer screws.
7. Tighten the strain relief screws.
8. Replace terminal box cover on back of dryer.
9. Plug dryer into wall receptacle.
10.Turn power on at breaker/fuse box.
Connecting a 4-wire Power Cord
Before starting this procedure, be sure the
power is turned off at the breaker/fuse box.
4-Wire Cord
3/4" UL-listed
Neutral
strain relief
Ground
prong
Power Supply Cord
You will need a 4-wire power supply cord with
four No. 10 copper wires and a matching 4-wire
receptacle of NEMA Type 14-30R, as illustrated
below. The fourth wire must be identifi ed with a white
cover and the ground conductor by a green cover.
To connect a 4-wire power cord to the dryer, follow
the steps below.
The numbers in the illustration correlate to the
step numbers.
12
4
5
Spade terminals with
upturned ends
Ring
terminals
Neutral
(White)
Ground
(green)
Customer Care Center, 1-800-898-1879, www.askona.com
1. Turn the power off at the breaker/fuse box.
2. Remove terminal block cover.
3. Use the strain relief attached below the terminal
block opening.
4. Remove center terminal block screw.
6
5. Remove ground wire (green with yellow stripes)
from external ground connector screw and
remove from center terminal block.
6. Connect ground (green) wire of cord to external
ground conductor screw.
7. Connect neutral (white) wire of cord under center
screw of terminal block.
8. Connect the other wires to outer screws.
9. Tighten the strain relief screws.
10.Replace terminal box cover on back of dryer.
11.Plug dryer into wall receptacle.
12.Turn power on at breaker/fuse box.
4
7
8