D&K Expression 42 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Laminator D&K Expression 42. D&K Expression 42 18 stron.

Mounting and Laminating using a SuperStick® pouch board:

1. Refer to the instruction sheet packed with each box of SuperStick® pouch boards for specific

instructions on mounting/laminating with a SuperStick® board.

2. Also, refer to the instruction sheet for information on Compatible Media, Process Conditions, and

Technical Information.

3. A SuperStick® Pouch Board consists of a foam mounting board with a piece of film on top. The film is

sealed to the board along one side of the shorter sides.

4. Carefully examine the board, determine which edge is sealed. There is a 1/8" tape edge on the

sealed end.

5. Starting at one of the corners opposite the sealed edge, gently lift and peel back the film. Care

should be taken not to break the sealed hinge.

6. Center the image to be laminated on the board and lay the film back over it.

7. Cover your print with the cover sheet packed in each box as marked. This is required on thick papers

to prevent adhesive from sticking to the rolls.

8. Set the control knob to the correct setting that matches the pouch board thickness.

9. Slowly insert the pouch board into the inlet opening. Ensure that the pouch board will enter centered

and straight. A gentle push may be required to start the board into the machine. Hold the edges of

the pouch board until it is engaged and the laminator begins pulling on its own.

10. The pouch board will feed through the laminator and automatically exit at the rear of the unit.

11. Support board as it exits the machine to keep heated board from curling down.

THE POUCH BOARD WILL BE HOT!

12.

13. If there is any dirt or adhesive on the surface of the board, it can be removed by dampening a lint

free cloth with Poly-Off and wiping the surface.

Allow it to lie flat while cooling.