D&K Monarchy Minikote EZ G3 Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Laminator D&K Monarchy Minikote EZ G3. D&K Monarchy Minikote EZ G3 15 stron.

C. Threading the Film

Remove the feed tray and the heatguard. Thread the lm as

shown in the gure on the right. Pull the lm around the idler

rollers as shown. Do not mistake the reinforcing bar for the

Do not mistake the reinforcing bar for the

idler roller

idler roller. Make sure the glossy and dull sides of the lm

Make sure the glossy and dull sides of the lm

are as indicated in the diagram

are as indicated in the diagram. Position the threading board

provided.

Turn power and keyswitch to on.

Start the motor by pressing the "Fwd" but-

ton. Feed the threading board and lm in

between the heat shoes. This will pull the

lm through the rollers until it comes out

the back of the laminator.

Slide the top and bottom lm rolls from side

to side on the mandrels so that the lm is

perfectly aligned top and bottom (Note:

overlap will cause the lm to deposit resi-

due on the heat shoes and rollers, so this

procedure is critical). Replace feed tray

and heat guard.

Laminator.com