D&R ClubMix Podręcznik - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik dla Mikser muzyczny D&R ClubMix. D&R ClubMix 20 stron.

3.0 AUXILIARY SECTION

There are two AUX send controls on each module. The second aux control is on a concentric knob on top of

the already fitted control.

Aux sends

The standard auxiliary sends are set pre and post-fader. Aux 1 is post fader and AUX 2 is pre fader. The aux

sends are designed to be post equal izer and post insert point.

3.1 VOICE OVER

The "Voice Over" switch sends a postfader signal to the control circuitry located in the master section to

attenuate music signals in a controlled amount for compact presentation.

4.0 THE PANPOT

This control (with a 4.5 dB loss at its center point) pans the signal between the left and right master buss .

5.0 CUE/ON

The Cue switch (pre fader listen) enables you to listen to the channel signal before the fader without effecting

the normal signal path to the master outputs.

The ON switch activates the input module when depressed. The On switch also closes contacts at the start

jack at the back of the console.

6.0 CHANNEL FADER

The channel fader has a slide length of 100 mm and is manufactured to give an exceptionally smooth feel in

operation .

7.0 CHANNEL IN/OUTPUTS

Located on the back of the console .

7.1 MICROPHONE INPUT

This is the XLR input for balanced condenser or dynamic microphones.

pin 1 is ground,

pin 2 is hot (in phase)

pin 3 is cold (out of phase).

7.2 LINE INPUT

This is a 1/4" tip ring sleeve jack which is balanced. The tip is hot, ring is cold and the sleeve is wired to

ground. This input has a sensitivity of -40dBu to 0 dBu.

The impedance is 10k Ohms. I t will accept any Line output of tape recorders, keyboards, CD players and so

on.

Clubmix manual page 4