1010music Laserbox Podręcznik użytkownika - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Jednostka sterująca 1010music Laserbox. 1010music Laserbox 3 stron.

Drukuj stronę

1010music Laserbox Podręcznik użytkownika

Color

All preset modes allow you to control the color of the signal. Touch the COL button on the Main screen to display the color

parameters screen. Press INFO to cycle through the parameters pages for the color parameters. You can configure the following

parameters on this screen:

Hue (can be modulated)

•

Saturation (can be modulated)

•

Rate

•

Amount

•

Waveform

•

The waveform parameter allows you to select a signal that will vary the color over time. Use this together with Rate and Amount to

control the waveform.

Position and Scale

Touch the POS button on the Main screen to control the position and scale of the projection. Press the INFO button to cycle through

the position and scale parameters pages.

The X Scale and Y Scale parameters adjust the size of the projection by stretching it along the X or Y axis. The Z Scale parameter

makes it look like the image is zooming in or out along the Z axis by scaling the image along both the X and Y axes simultaneously.

The position parameters, X Pos and Y Pos, allow you to move the image around within the range of the laser. When the position

puts the signal too close to the edge of the laser's range, the pattern will compress against the edge and become distorted.

All of the scale and position parameters can be modulated.

Rotation

Touch the ROT button on the main screen to control the rotation of the image along the Z axis. Imagine a pole going through the

center of the laser projection area coming straight out of the wall towards you. Z Axis rotation causes the image to spin around that

pole. You can control the Z rotation directly by the Z Axis value. You can use a waveform to control the rotation by setting the Z

Oscillator Amount and Z Oscillator Rate parameters.

All of the rotation parameters can be modulated.

Modulation

Laserbox supports modulation using external control voltage signals. Plug a +/- 5V CV signal into the CV MOD IN TS jacks to control

the ExtX modulation signals as follows:

Toolbox Input Jack

CV MOD IN 1

CV MOD IN 2

CV MOD IN 3

CV MOD IN 4

You can apply modulation to any parameter that has three black boxes above parameters in the top row or below parameters in the

bottom row. Touch one of these modulation boxes and laserbox displays the Modulation Source parameters. Select a modulation

Source (Ext1 through Ext4) and then specify the Amount of impact the source will have on the parameter. Configure an external source

to drive a signal to the corresponding CV MOD IN jack, and the parameter value will vary with the CV input signal. For example, you

can make the size of the projection pulse in and out over time by using a sinusoidal input to modulate the Z Scale parameter.

Learn More

Check for updates to this manual at https://1010music.com/laserbox-documentation-and-software.

Find community support, wish lists, firmware updates, and alternate firmware on our forum at https://forum.1010music.com.

12/12/18 5:16 PM

Modulation Source

Ext1

Ext2

Ext3

Ext4

Laserbox User Guide p. 3