Ambient Weather WS-8460 Podręcznik użytkownika - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Budzik Ambient Weather WS-8460. Ambient Weather WS-8460 17 stron. Clear view projection alarm clock with indoor temperature and color changing outdoor temperature
Drukuj stronę
channel at Channel 1. If you have more than one sensor, refer to Section 5.14.
3.2 Parts List
QTY
1
Clock
Frame Dimensions 6.42" W x 3.19"H x 2.24"D
(163W x 81H x 57D mm)
Wireless Transmitter (LxWxH): 4.0" L x 2.5" W x 1.5" D
1
1
UL Rated AC Adapter
1
User Manual
3.3 Powering Up
Note: The power up sequence must be performed in the order shown in this section (remote
transmitter FIRST, Display Clock SECOND) to avoid the Clock synchronization time out.
The Transmitter:
1. Remove the battery door on the back of the transmitter and insert 2 new AA batteries,
according to the polarity information marked on the battery compartment, and replace the
battery door, as shown in Figure 2. Place the transmitter about 5 feet from the clock.
The Clock:
1. Energize the battery by releasing the pull tab on the bottom of the clock.
2. Plug the AC adaptor into the DC jack of the clock.
3. Once the wireless transmitter has synced up to the clock, you can place the sensor outside.
Note: If no display is present after powering up the clock, press the reset button on the back of the
clock.
3.4 Siting the Wireless Transmitter Outside
It is recommended you place the remote sensor in a shaded area.
Direct sunlight and radiant heat sources will result in inaccurate temperature readings. Although the
sensor is weatherproof, it is best to mount in a well-protected area, such as an eve. Do not place in
standing water or snow.
Wireless signals are impacted by distance, interference (other wireless devices, wireless phones,
wireless routers, TVs and computer monitors), and transmission barriers, such as walls. In general,
wireless signals will not penetrate solid metal and earth (down a hill, for example).
The following is a table of reception loss vs. the transmission medium. Each "wall" or obstruction
decreases the transmission range by the factor shown below.
Medium
Glass (untreated)
Plastics
Wood
Brick
Concrete
Metal
Version 1.0
©Copyright 2016, Ambient LLC. All Rights Reserved.
Item
RF Signal Strength Reduction
5-15%
10-15%
10-40%
10-40%
40-80%
90-100%
Page 6