AMBILIFE L100 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Oczyszczacz powietrza AMBILIFE L100. AMBILIFE L100 16 stron. Photocatalytic air purifier

- click «On/Off» button on the control panel (Figure 3, p. 6).

For easy control, the installation is equipped with a remote control (DU, Figure 4 p.

6).

The buttons on the remote control correspond to the buttons on the dashboard:

To put the installation to work or turn off, click on/off;

- To switch modes of operation, click «MODE I» or «MODE II.»

Before you start operating the remote control, remove the transport film from the

remote's power supplies.

8. POSSIBLE SORES AND METHODS OF THEIR

Immediately turn off the power supply of the device if:

The device buttons don't work.

- the power cord or fork of the device is very heated;

There was a smell of smoke, unusual noise or vibration. (Fault table 1).

Fault

The air purifier doesn't work

The air purifier does not clean

the air from dust and odors

The air purifier produces a strong

noise

Before you go to the service center, do the above-mentioned operations to identify

and fix the fault.

If the fault cannot be fixed, or if water or foreign objects affecting the operation of the

device have got inside the air purifier, please contact the service center.

Attention! Before the maintenance of the device, it is necessary to remove the power

cord fork from the socket.

You can remove the accumulated dust on the lid by rubbing it with a soft cloth soaked

with water or a solution that does not contain surface-active substances (PAV).

Never:

Rinse the air filter with water or any other solution.

REPLACING FILTERS.

The frequency of air filter replacement is approximately one year. This period depends

on the intensity (duration) of the device's operation and the degree of air pollution. The

life of the filter is shortened when the device is used in kitchens and other rooms where

oil and soot vapors are present in the air.

Possible cause

The power cable plug is loosely

inserted into the power outlet

Blocked air intake hole

Clear the air intake hole or install new

filters

If the filters are heavily contaminated,

install new filters