Ambirad Vision VSOUH Manual de montagem e de instruções - Página 11
Procurar online ou descarregar pdf Manual de montagem e de instruções para Aquecedor Ambirad Vision VSOUH. Ambirad Vision VSOUH 20 páginas. Radiant tube heaters
Imprimir página2.2.9 Outer Canopy's
Remove the protective plastic coating.
The outer canopies are made up of identical half
covers (L) which engage into the side of the
inner reflectors and join at the centre by way of
a closing plate which holds the two halves
together. Install the outer canopies using the
following method;
2.2.8.1 Two Module Units
1. Slide on the two halves to cover the 1st
section of the heaters and fit closing plates to
each end to the second set of canopies.
2. Slide on two more outer canopies.
3. Stop short of the canopies already fitted and
fit closing plates (N).
4. Insert the ends of the second set of canopies
inside the first set at the central joint.
5. A slot is located 15mm from the end of each
canopy. Align each slot i.e. one on top of each
other and insert M8 self tapping screws
provided.
2.2.8.2 Three Module Units
1. Slide on the two halves to cover the centre
section of the heaters and fit closing plates to
each end (P).
2. Slide on two more outer canopies.
3. Stop short of the canopies already fitted and
fit closing plates (P).
4. Insert the ends of the second set of canopies
inside the first set at the central joint.
5. A slot is located 15mm from the end of each
canopy. Align each slot i.e. one on top of each
other and insert M8 self tapping screws
provided.
6. Repeat the procedure for 3rd set of outer
canopies.
2.2.9.3 Four Module Units
1. Slide on the two halves to cover the centre
section of the heaters and fit closing plates to
each end (P).
2. Slide on two more outer canopies.
3. Stop short of the canopies already fitted and
fit closing plates (P).
4. Insert the ends of the second set of canopies
inside the first set at the central joint.
5. A slot is located 15mm from the end of each
canopy. Align each slot i.e. one on top of each
other and insert M8 self tapping screws
provided.
6. Repeat the procedure for 3rd and 4th set of
outer canopies.
Doc No. 700021 Page 11 of 20