Ambirad DR 100 Informações para o utilizador, instruções de instalação e de manutenção - Página 2
Procurar online ou descarregar pdf Informações para o utilizador, instruções de instalação e de manutenção para Aquecedor a gás Ambirad DR 100. Ambirad DR 100 15 páginas. Radiant gas heaters
Imprimir páginaUSER INSTRUCTIONS
This unflued, gas fired, overhead radiant heater is designed for use in industrial and commercial buildings such as
warehouses, manufacturing plants, aircraft hangers, service garages, etc.
NOT FOR RESIDENTIAL USE!
Do not use in the home, sleeping quarters, attached garages, etc.
The manufacturer cannot anticipate every use which may be made of their heaters. Check with your local fire
safety authority if you have questions about local regulations.
IMPORTANT
This heater must be installed and serviced by a trained gas service technician only! Conversion of the heater for
use with other gases must be carried out by a trained gas service technician.
Read these instructions carefully before attempting to install, operate or service the heater.
Failure to comply with these warnings and instructions, and those on the heater, could result in personal injury,
death, fire, asphyxiation and/or property damage. Retain these instructions for future reference.
GENERAL INFORMATION
The following information should be reviewed before using or
installing this heater:
The heater features a fully automatic ignition and control system.
When the power is supplied to the heater the gas valve opens,
allowing gas to enter the burner. A spark is generated at the ignition
electrode and this is used to ignite the gas.
The electrodes are also used to monitor the flame. When the flame
has been established the sparking ceases and the heater
commences normal operation.
If a flame is not established, the spark is interrupted after a few
seconds and the gas valve closes. The heater will then lockout,
and will not make another attempt to ignite. The power supply to
the heater must be switched off and then switched back on again
before another ignition attempt is made.
WARNING
DO NOT STORE OR USE PETROL OR OTHER INFLAMMABLE VAPOURS AND LIQUIDS IN THE
VICINITY OF THIS OR ANY OTHER APPLIANCES.
WARNING
THIS APPLIANCE MUST BE EARTHED
WARNING
DO NOT TOUCH THE IGNITION OR FLAME DETECTION ELECTRODES OR ANY PART OF THE
IGNITION/FLAME DETECTION CIRCUIT WHILE POWER IS CONNECTED TO THE HEATER. THESE
PARTS CARRY HIGH VOLTAGES AT ALL TIMES AND WILL GIVE AN ELECTRIC SHOCK IF
TOUCHED.
2