Aero Storm 52 Manual de instalação e do utilizador - Página 16
Procurar online ou descarregar pdf Manual de instalação e do utilizador para Ventilador Aero Storm 52. Aero Storm 52 20 páginas.
Imprimir página
PROBLEM
Fan does not power
up.
No mains voltage going to fan.
Isolation switch turned off.
Batteries in the remote control flat
Fan is not
responding to the
remote control.
Fan not programmed properly
Fan Wobbles.
Hanger ball is loose in hanger bracket
Blades not a matching set
Loose Screws
Loose Hanger Bracket
(Warning: The ceiling
fan must be switched
OFF and the assistance of
Countersunk screws have been used
a licensed electrician may
be required.)
Fan is noisy
Loose Screws or Parts
Hanger Bracket could be loose
Light does not turn
No power to the fan.
on.
Loose wire in light assembly.
(Warning: The ceiling
fan must be switched
Issue with the remote control.
OFF and the assistance of
a licensed electrician may
be required.)
Fan does not move
The fan is in winter mode.
much air
One remote is
The remote is crossed programmed
controlling two
to two fans. Or two remotes are
different fans /
controlling one fan.
Removing a
second remote
programmed to a
fan.
NOTE: THIS FAN MUST BE INSTALLED BY A LICENSED AND QUALIFIED
15
ELECTRICIAN IN ACCORDANCE WITH LOCAL AUTHORITY REGULATIONS
TROUBLESHOOTING
POSSIBLE CAUSES
PROBABLE SOLUTIONS
Check the dwelling's fuse/box circuit breakers has not
failed / tripped and check that 240V is available at the
Terminal Block
Check isolation switch is turned on.
Change the Batteries in the remote control - always
install brand new batteries (not lithium).
Check that the handset has been programmed to the
receiver (refer to page 8)
Check the hanger ball is locked into the hanger bracket
groove
Check each blade to make sure that the weights are the
same. (there is a 3gm buffer)
Check all screws are tight - be careful to never over
tighten the screws.
Check that the bracket is tight against the ceiling and
the ceiling and ceiling structure is not moving.
Countersunk screws will make the fan wobble and
either now or later allow the bracket to move. Replace
Countersunk screws with screws that have been
supplied in box
Check all screws and parts are secured firmly - be
careful to never over tighten the screws. Ensure there
are no loose parts moving inside the motor housing.
Check that the ceiling bracket is secure.
Check circuit breakers / Fuses / isolation switch.
Check wires in light kit assembly.
Refer to above issues pertaining to the remote control
for a solution.
Using the remote control change the fan from winter
(reverse) to summer mode.
Follow the programming steps on page 11 twice in
sucession using the orgional remote. This will delete
all other remote controls attached to the fan.