Flo King Permacore Reusable Carbon Bag Instruções de desmontagem e limpeza - Página 2
Procurar online ou descarregar pdf Instruções de desmontagem e limpeza para Bomba de água Flo King Permacore Reusable Carbon Bag. Flo King Permacore Reusable Carbon Bag 3 páginas.
Imprimir páginaF I L T E R
S Y S T E M S
FLO KING PERMACORE REUSABLE CARBON BAG
1. Insert filter cartridge into bag. Make sure to keep cartridge in center of bag.
2. Tighten nut at bottom of bag onto threaded end of filter cartridge (Fig. 1).
3. Fill bag with carbon until it reaches bottom of Permacore Head—about 1-1/2" (4 cm)
from top of filter cartridge (Fig. 2). Caution: Do not overfill bag and do not allow carbon to
get into center of filter cartridge!
4. Stretch Carbon Retainer Ring over Permacore Head (Fig. 3).
5. Lower Carbon Retainer Ring until it is positioned just above carbon on lower groove
of Permacore Head (Figs. 4 and 5).
6. Cross strings on top of bag to prevent bag seams from pulling apart. Pull string on
right side of Bag about 3" (8 cm) longer than string on left side of bag (Fig. 6). Wrap strings once
around top of bag (Fig. 7).
7. Position bag so that vertical seam on bag is on your left. Loosely tie square-knot as
close as possible to vertical seam on bag (Fig. 7).
8. Slowly pull string tight while pushing square knot toward Permacore Head (Fig. 8).
(Note: It is advisable to use gloves to pull string tight. An even better idea is to make an impro-
vised tool as shown in Fig. 8, using 1/2"-diameter pipe with a couple of drilled holes. Thread
bag strings through pipe holes to improve leverage, then use tool as a handle to help tighten bag
strings.)
9. If necessary, use a pointy tool, like scissors, to lift and move material at top of bag
closer to Permacore Head in order to fully close bag and prevent carbon from escaping (Fig. 9).
10. Pull strings until tight against top of bag. Then use a strong jerking motion to fully
tighten knot.
11. Wrap strings around top of bag a second time, then tighten and tie another square knot
for additional security.
12. Tie strings together to make a loop for use as a handle. The handle is helpful when
lowering bag into solution for carbon treatment.
CUSTOM MASTERS, INC. • 401 LAKE BENNETT CT., LONGWOOD, FL 32750-6341 USA • 407-331-4634 FAX 407-331-0575
11/05
IN-TANK TECHNOLOGY
TM
REASSEMBLY INSTRUCTIONS
REASSEMBLY INSTRUCTIONS
(REFER TO PHOTOS ON PAGE 3)
Page 2