ACR Heat Products HERITAGE Manual de instruções de instalação e funcionamento - Página 6
Procurar online ou descarregar pdf Manual de instruções de instalação e funcionamento para Lareira de interior ACR Heat Products HERITAGE. ACR Heat Products HERITAGE 9 páginas.
Imprimir página
6. Place the canopy on the stove resting the base of the canopy on the
right angle brackets. Ensure there is a minimum 15mm gap between the
rear wall of the fireplace and the rear of the canopy to allow the hot air to
circulate.
When satisfied with the position of the canopy, attach each right angle
bracket into the canopy base and secure with the supplied nut & bolt.
7. Attach the base cover to the front of the appliance by sliding the cover
into the gap provided by the leg bolts.
SOME FACTS ABOUT YOUR STOVE
This appliance is fitted with air controls which should be operated as
follows:-
PRIMARY AIRSLIDE
(Located to the right hand side below the doors)
Pushed in = CLOSED
Pulled out = OPEN
SECONDARY AIRSLIDE
(Located to the right hand side above the doors)
Lever to the left = CLOSED
Lever to the right = OPEN
To open the door, point the door handle up. To close the door, point the
door handle horizontally.
The inside of the stove is lined with vermiculite panels. These will break
under strong impact. Therefore, please ensure that when reloading your
stove, logs are placed onto the stove base rather than thrown to avoid
any breakages. The vermiculite panels are a "wear and tear" component
and are not covered by warranty.
FIRST FIRING OF APPLIANCE
During the first firing of your stove, the high temperature paint will cure.
This process will give off some smoke for a couple of hours depending on
the temperature of the fire.
This is perfectly normal but we do
6